The Cutting System - Husqvarna Automower 305 Workshop Manual

3. Remove the screw for the holder of the charging
plates.
4. Lift up and remove the holder.
5. Remove the charging plates and the charging plates
cable.
6. Install in opposite sequence.

6.15 The cutting system

6.15.1 To replace the blade motor
WARNING: Be careful when working with the
blades on the rotating disc.
1. Set the cutting height adjustment to MAX.
2. Remove the top cover. Refer to
install the top cover on page 18 .
3. Remove the body. Refer to
the body on page 18 .
4. Remove the upper chassis. Refer to
install the upper chassis on page 19 .
1414 - 001 -
To remove and
To remove and install
To remove and
5. Disconnect the blade motor cable from the main
circuit board.
6. Remove the motor cable from the main circuit board.
7. Remove the 3 screws that holds the skid plate.
8. Remove the screw (hex key 4) that holds the
bearing.
9. Remove the 3 screws that holds the blade disc.
10. Remove the screw for the foot guard.
11. Twist the foot guard clockwise and lift it up.
Repair instructions- 29