Wheels And Wheel Motors - Husqvarna Automower 305 Workshop Manual

12. Remove the sealing strip, the cable gland and the 2
screws for the cutting module.
13. Lift up and remove the cutting system.
14. Install in the opposite sequence.

6.16 Wheels and wheel motors

6.16.1 To replace the front wheels
1. Push the ON/OFF button to switch off the product.
The product is disabled when the indicator lamp is
not lit.
2. Turn the product upside down.
3. Push to release the clips and lift up the wheel to
remove it.
4. Install in opposite sequence.
6.16.2 To replace the rear wheels
Note: When using the terrain wheels with weights,
special settings are needed to compensate for additional
weight because collision is detected by the current in the
30 - Repair instructions
wheel motor. Enter the menu
and enable Terrain kit.
1. Remove the hub cap.
2. Remove the nut (24 socket wrench) and the washer.
24 mm
3. Remove the wheel.
4. Install in the opposite sequence.
6.16.3 To replace the wheel motors
1. Remove the top cover. Refer to
install the top cover on page 18 .
2. Remove the body. Refer to
the body on page 18 .
3. Remove the upper chassis. Refer to
install the upper chassis on page 19 .
4. Disconnect the wheel motor cable from the main
board.
5. Remove the wheel. Refer to
wheels on page 30 .
Accessories > Terrain kit
To remove and
To remove and install
To remove and
To replace the rear
1414 - 001 -