Cutting System - Husqvarna R 214C Workshop Manual

3. Disconnect the ball joint from the hydrostatic
transmission cable by removing the lock spring.
4. Make sure that the forward pedal is fully pushed.
5. Bend the arm to fully and do a check that the ball
and the ball socket in the ball joint align.
6. Adjust the ball socket on the cable until it is correctly
above the ball on the lever arm.
Note: Make sure the that locking spring goes
through the two holes in the ball socket.
7. Turn the ball socket two more times.
8. Assemble the ball joint and the locking spring for the
ball joint.
9. Tighten the locknut for the ball socket on the cable.
10. Attach the transmission cover.
9.5.6.3 To replace the oil in the transmission
1. Put a container below the drain plugs.
2. Open the 2 plugs to drain the transmission.
3. Attach the drain plugs.
4. Fill the transmission oil tank with oil.
5. Bleed the transmission. Refer to
system on page 31 .
6. Do a test of the product and fill with oil to the correct
level in the transmission oil tank.
1592 - 002 - 11.02.2021
To bleed the drive

9.6 Cutting system

9.6.1 To put the cutting deck in servicing position
WARNING: The tension spring for the drive belt
can break and cause injury. Use protective
glasses.
To remove and attach the cutting
1. Do step 1–9 in
deck on page 9 .
2. Hold the front edge of the cutting deck with two
hands and pull it out until it stops.
3. Lift the cutting deck to vertical position until a click
sound is heard. The cutting deck is locked
automatically in the vertical position.
9.6.2 To put the cutting deck in mow position
1. Hold the front edge of the cutting deck with your left
hand.
2. Loosen the lock with your right hand.
Repair instructions - 37