Charging Station - Husqvarna Automower 305 Workshop Manual

6. Remove the 4 screws for the wheel motor.
7. Remove the wheel motor.
8. Install the new wheel motor.
9. Install in opposite sequence.
6.16.4 To install or replace the wheel brushers
1. Remove the top cover. Refer to
install the top cover on page 18 .
2. Remove the wheel brush holders. Lift the clips on
the wheel brush holder and push forward.
1414 - 001 -
To remove and
3. Insert the wheel brush in the slot from the underside
in an angle and push it down into place.
A
4. Install in the opposite sequence.

6.17 Charging station

The charging station consists of a baseplate and a
charging tower with the charging station's circuit board
and the contact plates. When the product's battery does
not recharge or cannot contact the charging station this
may be due to worn contact plates in the charging
station. Also check the charging plates on the product.
6.17.1 To remove and install the charging station
and the charging station cap
This section gives information on how to remove all
parts of charging tower. For service or to replace spare
parts all steps may not be needed.
1. Disconnect the power supply.
2. Push the button and tilt the charging station cap.
3. Disconnect all cables from the charging station.
4. Remove the 2 screws on the front of the charging
station.
B
Repair instructions- 31