11. When you connect the cables make sure to put the
cables in the cable holders. To put the cables into
position in the lower chassis:
Note: Attach a new warranty seal. The warranty seal
must be included and unbroken for the warranty to be
valid.
CAUTION: The cable routing is important to
avoid disturbance of the loop sensor board.
CAUTION: Always connect the HMI cable
before the power cable to avoid current spikes
that may harm the circuit boards or the battery.
CAUTION: Make sure that no cables are
pinched.
CAUTION: Replace the sealing strip each time
you install the upper chassis.
20 - Repair instructions
6.6 To replace the rear bumper
1. Remove the body. Refer to
the body on page 18 .
2. Remove the 2 screws that hold the rear bumper to
the body.
3. Remove the rear bumper.
4. Install in the opposite sequence.
6.7 To replace the rear body suspension parts
1. Remove the top cover. Refer to
install the top cover on page 18 .
2. Remove the body. Refer to
the body on page 18 .
3. Fold the rear body suspension part.
4. Lift up to remove.
5. Install in the opposite sequence.
6.8 To replace the front body suspension parts
1. Remove the top cover. Refer to
install the top cover on page 18 .
2. Remove the body. Refer to
the body on page 18 .
To remove and install
To remove and
To remove and install
To remove and
To remove and install
1414 - 001 -