Husqvarna Automower 305 Workshop Manual page 28

6.14.1 To replace the battery
1. Remove the top cover. Refer to
install the top cover on page 18 .
2. Remove the body. Refer to
the body on page 18 .
3. Remove the upper chassis. Refer to
install the upper chassis on page 19 .
4. Disconnect the battery cable from the main circuit
board.
5. Remove the screw for the battery holder.
28 - Repair instructions
To remove and
To remove and install
To remove and
6. Push to detach the clips and lift up the battery
holder.
7. Lift up and remove the battery.
8. Install a new original battery in the battery holder.
9. Install in opposite sequence.
6.14.2 To replace the charging plates
If the battery of the product does not recharge this may
be because of worn or damaged charging plates. Also
do a check of the contact plates on the charging station.
To replace the contact plates in the charging
Refer to
station on page 32 .
1. Remove the top cover. Refer to
install the top cover on page 18 .
2. Remove the body. Refer to
the body on page 18 .
To remove and
To remove and install
1414 - 001 -