Screw Fasteners - Husqvarna Automower 305 Workshop Manual

Action
Cleaning
Clean the charging station by using a wet brush and/or a moist cloth.
Charging plates
Examine and polish the charging plates on the product and the charging plates
on the charging station.
Docking
Check that docking and charging works correctly.
Charging
Fully charge the battery.

7.2 Screw fasteners

All screws are made from stainless material or rustproofed with zinc plating. Article numbers are found in the spare
parts list (IPL).
The tightening torque must be attained, otherwise there is not a satisfactory seal against moisture etc.
Fastener
Upper to lower chassis
Rear bumper to body
Holder charging strips
Support for hatch
Front sensor circuit board holder
Communication circuit board
Battery holder
Service plug
Wheel motor to lower chassis
Rear wheel
Blade disc
Blade disc bearing
Blades
Bearing cover, skid plate
Cover cutting system
Height adjustment
Cutting motor to lower chassis
Clamp for main circuit board and rear sen-
sor circuit board
Foot guard
Charging station, lid
Charging station, frame
Charging station, contact strips
Charging station, base and housing
36 - Service
Hardware
Screw, 5 x 16 mm
Screw, 5 x 16 mm
Screw, 5 x 16 mm
Screw, 5 x 16 mm
Screw, 5 x 16 mm
Screw, 5 x 16 mm
Screw, 5 x 16 mm
Screw, 5 x 16 mm
Screw, 5 x 16 mm
Nut, M16
Screw, M4 x 8 mm
Screw, M6 x 8 mm
Screw, M4 x 10 mm
Screw gray, 4 x 14 mm
Screw, 5 x 16 mm
Screw, 5 x 16 mm
Screw, 5 x 16 mm
Screw, 5 x 16 mm
Screw, 5 x 16 mm
Screw gray, 4 x 14 mm
Screw gray, 4 x 14 mm
Screw gray, 4 x 14 mm
Screw gray, 4 x 14 mm
Explanation
Polish contact surfaces on both
the product and the charging sta-
tion with a fine grade emery cloth.
Symptoms during dock-
Refer to
ing on page 46 and Symptoms
during charging on page 47 .
Always charge the battery fully
before winter storage. If this is not
done, the battery may be ren-
dered useless due to coltage lev-
els dropping too low.
Tool
Torx 20
Torx 20
Torx 20
Torx 20
Torx 20
Torx 20
Torx 20
Torx 20
Torx 20
24 socket spanner
Cross screwdriver
Allen key 4
Flat/cross screwdriver
Torx 20
Torx 20
Torx 20
Torx 20
Torx 20
Torx 20
Torx 20
Torx 20
Torx 20
Torx 20
Tightening
torque (Nm)
1.8
1.8
1.8
1.8
1.8
1.0
1.8
1.2
1.5
18
1.8
5.5
1.8
1.2
1.8
1.8
1.8
1.8
1.8
0.8
1.2
0.8
1.2
1414 - 001 -