4. Push the clips inwards and lift up to remove the
support.
5. Remove the damaged ventilation filter.
6. Clean fully around the mounting surfaces.
7. Attach the new filter. Make sure that the adhesive
surfaces attach correctly to the chassis.
8. Install in the opposite sequence.
6.11 To replace the STOP button
Note: The magnet in the STOP button must be installed
correctly for the correct operation of the STOP button. If
this is not the condition, it is necessary to replace the
STOP button.
To remove and
1. Remove the top cover. Refer to
install the top cover on page 18 .
To remove and install
2. Remove the body. Refer to
the body on page 18 .
22 - Repair instructions
3. Pull out one side of the stop button.
4. Pull the STOP rearward to remove it.
5. Install in the opposite sequence.
6.12 To replace the hatch
To remove and
1. Remove the top cover. Refer to
install the top cover on page 18 .
To remove and install
2. Remove the body. Refer to
the body on page 18 .
3. Remove the 2 screws for the support.
4. Push the clips inwards and lift up to remove the
support.