Adjusting X Motor Gear - Janome Memory Craft 10001 Servicing Manual

If the X-motor gear sound is noisy when sewing the embroidery stitches, follow the
instructions below.
y

Adjusting X Motor Gear

e
t
r
q
w
To remove:
1. Remove the base unit (see page 5).
2. Remove the presser foot.
3. Remove screw A
4. Attach the X and Y motor connectors to PC
board A.
5. Turn the Power ON and select
Monogramming in the Embroidery Mode.
6. Select large "A" in Gothic style and
memorize it 3 times.
7. Lower the presser bar.
8. Insert a piece of paper
thread tension discs as shown so that the
needle thread sensor will not work.
9. Run the machine and loosen screws B
(2 pieces) and move the X-motor
detect the quietest position, while the
carriage is moving in lateral direction then
tighten the screws
10. Return the carriage to the home position
and turn the Power OFF.
11. Pull the X and Y motor connectors and
secure the nylon grip with screw A.
12. Reattach the base unit.
q
Screw A
w
Nylon Clip
e
Insert the Piece of Paper
r
Screws B (2 pieces)
t
X-Motor
y
Adjust the Carriage Position when it moves in
the Direction of the Arrow
39
q w
and nylon clip .
e
between the
t
to
r
.
r