Adjusting Presser Foot Sensor - Janome Memory Craft 10001 Servicing Manual

Ver.
Main
Slave Ver.
8 Adjust Brightness
BH Sensor
SEW TEST
Foot Sensor
Bobbin
Foot UD
Test Clear EEPROM
SET
q
t

Adjusting Presser Foot Sensor

Check Foot Sensor
L
OK
?
e
r
w
y
To adjust foot sensor position
1. Start the machine in Adjusting Mode. Turn the
Power ON while pressing the Start/Stop
button and Reverse button at the same time.
(Keep pressing both buttons until the LCD
shows Adjusting window.)
2. Press the "Foot Sensor" key on the touch panel.
3. Attach the standard presser foot and set the
pressure dial at 3 and lower the feed dog and
the presser foot.
4. Lower the needle bar to the lowest position.
5. Loosen the foot sensor shield plate screw
6. Move the foot sensor shield plate
untill it touches the sensor
the Touch Panel.)
7. Remove the standard foot
presser bar. (H will appear on the Touch Panel.)
8. Change the pressure dial to 2.
9. Change the foot to Embroidery Foot P and
slowly lower the presser foot lifter.
10. Turn the handwheel and move the needle bar
to the highest position.
11. When slightly moving the foot sensor shield
w
plate within its play, check the indication
on the Touch Panel.
If the screen shows "H": The Foot Sensor is
If the screen shows "L": Readjust the height
q
Set screw
w
Butt it slightly
e
Foot Sensor Shield Plate
r
Sensor
t
Standard Foot
y
Lowest Needle Position
27
q
.
w
to the left
e
. (L will appear on
t
and lower the
properly adjusted.
Press the OK key
and turn the Power
OFF.
of Embroidery Foot
P and proceed with
the adjusting steps
again from step 1 to
step 7.