Adjusting Needle Drop Position - Janome Memory Craft 10001 Servicing Manual

When the straight stitch is selected on the touch panel, the needle should be positioned at the
center of the needle plate hole and when the maximum zigzag width ( 7 mm) is selected, the
standard clearance at the outside of both the left and right sides should be 0.2 mm or more as
shown below.
r
e
t
A = B

Adjusting Needle Drop Position

q
w
t
1. Remove the top cover, and select the pattern
No.1 (Straight stitch) and lower the needle to
its lowest position by turning the handwheel.
q
2. Loosen screw
w
connecting rod
needle comes to the center of the needle plate
e
hole .
3. Select the pattern No.8 (Zigzag) and set the
zigzag width at 7.0 mm.
4. Turn the handwheel toward you and check the
clearance at the outside of both the left and
right sides. It should be 0.2 mm or more
shown below.
5. Reattach the top cover.
q
Screw
w
Zigzag Width Connecting Rod
e
Needle Plate Hole
r
Needle # 14
t
0.2 mm or more
7
, move the zigzag width
to the right or left until the
t
as