Adjusting X And Y Sensors (Instant Adjustment) - Janome Memory Craft 10001 Servicing Manual

Adjusting X and Y Sensor (Instant Adjustment)
q
t
u
i
w
y
e
r
To adjust X and Y sensor (without removing
the base unit):
1. Remove the base cover.
2. Remove the presser foot holder and attach
the embroidery hoop A.
3. Place the template
4. Turn the Power ON and select the
Embroidery Mode, then press pattern No.1.
5. Turn the handwheel by hand to check that
the needle drops into the starting position
(rounded hole) on the template.
6. Turn the Power OFF.
7. If the needle position shifts in Y direction,
loosen screw A
r
fixing plate
t
position .
8. If the needle position shifts in X direction,
loosen screw B
fixing plate hole and adjust the X shield plate
u
position .
9. Turn the Power ON and select pattern No.1
on the Embroidery Mode, then check the
start position
10. Return the carriage to the home position and
turn the Power OFF.
11. Remove the template
hoop, then reattach the base cover.
q
Template
w
Start Position
e
Screw A
r
Y Sensor Fixing Plate
t
Needle
y
Screw B
u
X Shield Plate
i
Sheet Cover Fixing Plate Hole
38
q
on the hoop.
e
and move the Y sensor
to adjust the needle drop
y
through the sheet cover
w
.
q
and the embroidery
w