Ver.
Main
Slave
Ver.
8 Adjust
Brightness
BH Sensor
SEW TEST
Foot Sensor
Bobbin
Foot UD
Test
Clear EEPROM
SET
r
t
Adjusting Presser Foot Lifter Sensor
Foot UD
H
OK
?
q
w
e
To Adjust the presser foot sensor:
1. Start up the machine in Adjusting Mode.
Turn the Power ON while pressing the
Start/Stop button and Reverse button at the
same time. (Keep pressing both buttons until
the LCD shows Adjusting window.)
2. Press Foot UD key on the touch panel.
3. Remove the top cover.
4. Remove the pressure dial
5. Loosen the Screw A
e
plate
and make sure the screen shows H
when the presser foot is raised and the
screen shows L when the presser foot is
lowered, then tighten the screw
6. Press the OK key and turn the Power OFF.
7. Reattach the pressure dial
8. Reattach the top cover.
q
Pressure Dial
w
Screw A
e
Fixing Plate
r
Thread Releasing Lever
t
Thread Releasing Plate
* Check if the sensor works properly when the
pattern # 16 is selected.
28
q
.
w
to move the fixing
w
.
q
.