Adjusting Height Of Embroidery Foot P - Janome Memory Craft 10001 Servicing Manual

The space between the needle plate and the bottom surface of the Foot P should be 0.7 to 1.5
mm, when the needle bar is at its lowest position.

Adjusting Height of Embroidery Foot P

e
q
r
w
t
y
1. Remove the top cover.
2. Lower the needle bar and lower the presser
foot lifter. Set the pressure dial to 2
3. Insert the 1.2 mm thickness gauge between
the Embroidery Foot P
4. While pressing the Presser Bar Actuator
down against the upper shaft cam, loosen
r
Screw and tighten it again.
5. Chech that the space is set between
t
0.7 - 1.5 mm
6. Reattach the top cover.
q
Presser Dial
w
Embroidery Foot P
e
Presser Bar Actuator
r
Screw
t
Space 0.7 - 1.5mm
y
Lowest Needle Position
Note: After adjusting the Embroidery Foot P
height, make sure to adjust the presser
Foot sensor (see page 27).
20
q
w
and the needle plate.
.
.
e
w