Replacing Slide Volume / Printed Circuit Board F - Janome Memory Craft 10001 Servicing Manual

Replacing Slide Volume / Printed Circuit Board F

To replace the slide volume and printed circuit board F, follow the instructions below.
y w
q e r
t
Replacing the slide volume
e
To remove:
1. Remove the front cover unit.
2. Pull out the slide volume connector
q
from the printed circuit board F
3. Remove the CS rings 3 (2 pieces)
and the slide volume
Printed circuit board F
To remove:
1. Remove the front cover.
2. Pull out the connector from the
printed circuit board A and the slide
volume connector
3. Remove screws (3 pieces)
CS ring 3
circuit board F
To attach:
4. Follow the above procedure in
reverse.
q
Slide Volume Connectors
w
Printed Circuit Board F
e
CS Ring 3 for Slide Volume
r
Slide Volume
t
Screws (3 pieces)
y
F Board Connector
25
r
.
q
.
t
and a
e
, then remove the printed
w
.
w
.
e