Replacing Dc Motor And Motor Belt Tension Adjustment - Janome Memory Craft 10001 Servicing Manual

Replacing DC Motor and Motor Belt Tension Adjustment

q
w
e
e
r
t
31
Replacing DC motor:
To remove:
1. Remove the belt cover.
2. Remove the screw A
3. Pull out the motor connector
printed circuit board A.
4. Remove screws B (2 pieces)
the motor.
To attach:
5. Follow the above procedure in reverse.
Adjusting motor belt tension
To adjust:
1. Tighten screws B (2 pieces)
2. Adjust the belt deflection to about 5.0 mm
by pressing the middle of the motor belt with
your finger with approximately 200 grams
of pressure.
3. Tighten the screws firmly
q
Screw A
w
Motor Connector
e
Screws B (2 pieces)
r
Deflection 5 mm
t
Pressure 200 grams
q
and the moter belt.
w
from the
e
and replace
e
temporarily.
t
e
.
r