Adjusting X And Y Sensors - Janome Memory Craft 10001 Servicing Manual

w
e

Adjusting X and Y Sensors

t
y
q
To adjust the X and Y sensors:
1. Turn the Power ON to return the carriage to
the home position.
2. Turn the Power OFF and then remove the base
unit (do not disconnect X, Y-motor
connectors).
3. Loosen screw A
to 5 mm by moving the Y sensor attaching
e
plate .
r
4. Turn the Power ON and make sure if the
dimension Y
u
repeat steps 2 and 3.
5. Loosen screw B
t
to 69.5 mm and dimension X-2
by moving the X shield plate
6. Turn the Power ON and make sure if the
dimensions are properly adjusted. If not,
repeat steps 2 and 5.
7. Tighten the screws.
8. Reattach the base unit.
q
Screw A
w
Y (2.5 mm)
e
Y Sensor Attaching Plate
r
Screw B
t
X-1 (69.5 mm)
y
X-2 (3 mm) between the edge of carriage and Arm
u
X Shield Plate
37
q
to adjust dimension Y
w
is properly adjusted. If not,
r
to adjust dimension X-1
u
.
w
y
to 3 mm