Table of Contents
Advertisement
MC 9500
If the machine is noisy when sewing an embroidery design, adjust the X-Motor as follows.
5
6
Adjusting X Motor Gear
3
4
1
2
www.promelectroavtomat.ru
To remove:
1 Remove the base unit (See page 5).
2 Remove the presser foot.
3 Remove Screw (A)
cords.
Adjustment procedure:
4 Connect the X and Y motor connectors to printed
circuit board A.
5 Turn the power switch "ON" and select the 3 large "A"s
of Gothic of the monogramming.
6 Lower the presser foot after the carriage moves to the
sewing position.
7 To unable the needle thread sensor, insert a piece of
paper
3
into the channel as shown.
8 Run the machine and loosen Screws (B)
While the carriage is moving in the direction of arrows
6
, adjust the X-Motor position where the lowest noise
is obtained and tighten Screws (B)
9
Return the carriage to the stored position and turn
the power switch "OFF".
10 Pull the X and Y motor connectors out from the printed
circuit board (A), then tighten screw (A) to place the
nylon clip
.
2
11 Connect the X, Y motor connectors to the printed circuit
board A again.
12 Reattach the base unit.
1
Screw (A)
2
Nylon clip
3
Insert a piece of paper
4
Screw (B)
5
X-Motor
6
Carriage moving in lateral direction
37
1
and Nylon clip
from the
2
4
4
firmly.
(2 pieces).
Advertisement
Table of Contents
