Adjusting Needle Threader Switch - Janome Memory Craft 10001 Servicing Manual

Adjust the upper switch position as follows if the instructional display will not disappear.
q
w
r
e

Adjusting Needle Threader Switch

q
t
y
1. Remove screws A
the motor cover
q
Screws A (2 pieces)
w
Motor Cover
e
2. Loosen screw
r
switch position by moving it up or down, so
that the needle threader stops with a 3 mm
t
gap between the slider
of the guide slot.
e
Screw B
r
Slider
t
Approximately 3 mm Gap
y
Switch
3. Attach the motor cover with Screws A.
36
q
( 2 pieces) and remove
w
.
and adjust the position of
y
and the top end