MC350E
Replacing DC Motor and Motor Belt Tension Adjustment
A
B
B
D
C
Replacing DC Motor
1. Remove the belt cover. (See page 2)
2. Remove the motor belt.
3. Remove the Motor connector
circuit board "A" (Main board).
4. Remove Screws
motor.
5. Attach the motorand tighten Screws)
slightly.
Adjusting motor belt tension
1. Adjust the Belt deflection to about 5.0 mm
pressing the middle of the motor belt with your
finger with approximately 200 grams
A
Motor connector
B
Screws
C
Belt deflection (5 mm)
D
Motor belt pressure (200 gram)
24
A
from the printed
B
(2 pieces) and replace the
B
(2 pieces)
D
C
by
of pressure.