Adjusting Presser Foot Sensor - Janome MC9500 Service Manual

MC 9500
Main
Slave DC1
Brightness Foot UD
Read Card PH Sensor
Solenoid BH Sensor
Bobbin Foot Sensor
Main
Slave DC1
Check Foot Sensor
H
3
1
4

Adjusting Presser Foot Sensor

Sensor Off
Aging
Sew Test
SET
8 Adjust
SET
OK
2
5
www.promelectroavtomat.ru
To adjust foot sensor position
1 Start the machine in "Adjust Mode". Turn the power
switch "ON" while pressing the Start/Stop button at the
same time. (Keep pressing both buttons until LCD shows
Adjust Mode.)
2. Press the "Foot Sensor" key on the touch panel.
3 Attach the Standard presser foot
dial at "3" , lower the feed dog and the presser foot
4. Lower the needle bar to the lowest position
5 Loosen the Foot sensor shield plate screw
6 Move the foot sensor shield plate
until it touches the sensor
("L" will appear on the touch panel.)
7. Remove the standard foot
(H will appear on the touch panel.)
To check:
8 Set the pressure dial at "2".
9 Change the foot to Embroidery foot P and slowly lower
the presser foot lifter.
10 Turn the handwheel to raise the needle bar to its
highest position.
11 When slightly moving the foot sensor shield plate
within its play, check the indication on the touch panel.
If the screen shows "H":
If the screen shows "L":
1 Screw
2 Foot sensor shield plate
3 Sensor
4 Standard foot
5 Lowest needle position
29
4 , set the pressure
5 .
.
1
2
to the left most
lightly.
3
and lower the presser bar.
4
The foot sensor is properly
adjusted. Press the "OK"
key and turn the power
switch "OFF".
Readjust the height of
Embroidery foot P and
proceed with the adjusting
steps again from step 1 to
7.
5 .
2