Chapter B Cable And Connector Maintenance; Power And Ecu Harness Maintenance; Hawkeye Boom Harness Connector Maintenance - Raven Hawkeye Installation Manual

For agco rogator rg900; agco rogator rg1100; agco rogator rg1300

Hide thumbs Also See for Hawkeye:

Table of Contents

APPENDI X

1. Disconnect the ECU harness connector and inspect for signs of moisture or corrosion.

2. If moisture of corrosion is detected, use Deoxit D5, brushes, and compressed air to clean and dry the

connector.

3. When clean, apply a coating of Corrosion X HD to the connector mating surfaces and contacts.

4. Reattach the connectors.

Prior to connecting the Hawkeye

following steps to all 6-pin NCV connectors and 19-pin circular connectors between the boom cables and ECU

cable connections to ensure high quality connections:

1. Verify the NCV connectors and the accompanying boom cable connectors are free of moisture, contamination,

or oxidation. Oxidation will appear as a dry, white coating on the contacts. If any connectors show signs of

moisture, contamination, or oxidation, perform Step 2 - Step 6. If this is a new installation, skip to Step 7. All

components listed below can be ordered in the Hawkeye

692).

2. Spray the connection with a deoxidizing agent (DeoxIT D5 is recommended (P/N 222-4001-006)).

Cable and Connector Maintenance: Power and ECU Harness Maintenance

C ABLE AND CONNECTOR

C H A P T E R B

MAINTENANCE

boom cable to the Hawkeye

Nozzle Control Valves (NCV), perform the

NCV Connection Maintenance Kit (P/N 117-0171-

Table of Contents