Password Access; Setting The Heating Parameters - Riello Condexa PRO Series Installation, Technical And Maintenance Manual

Display Settings
" "
Year
" "
Date Separation Character
"
Day Of Week
" "
Seconds
" "
3.1.3

Password access

To access the parameters, press the MENU key and select "Set-
tings" with the ▲ / ▼ keys.
Menu
" "
Domestic Hot Water (DHW)
"
Information
" "
Settings
" "
System Test
" "
Confirm with the ● key and select "Boiler settings" with the ▲
/ ▼ keys
Settings
" "
General Settings
" "
Boiler Settings
" "
Press the ● key to confirm.
− The system will now ask you to enter a password (the
password is required for thermal module settings only):
Password
" "
0
4Digits
" "
-
" " "
Short Text
" "
No
" "
"
* * *
Enter one digit at a time using the ▲ / ▼ keys to increase/de-
crease the numeric value. When you have set the right value,
confirm by pressing the ● key.
The system provides for three types of access:
USER (password not required, e.g. password No. 0000)
INSTALLER (password No. 0300)
MANUFACTURER
9
After it is entered, the password is active during display and/
or parametrisation. If the display is inactive for a few min-
utes, it needs to be re-entered.
3.1.4

Setting the heating parameters

The parameter 1establishes the thermal module's various heat-
ing operation modes.
Mode 0
(Operation with room thermostat/heat demand and fixed heat-
ing setpoint)
In this mode, the thermal module operates with a fixed set-
point (controlled by the parameter3) based on whether the
room/heat demand thermostat's contact is closed or not.
The set-point value can be entered directly, without entering in
the parameter list, by accessing the "CH" menu in the following
way:
Press MENU and select "Central heating" using the ▲ / ▼ keys.
Press the ● key to confirm.
Menu
" "
Central Heating (CH)
"
Domestic Hot Water (DHW)
"
Information
" "
Settings
" "
After the selection, use the ► key to highlight the value and use
the ▲ / ▼ keys to change the selected value. Press the ● key to
confirm/save the new settings..
Central Heating (CH)
"
CH Setpoint
" "
the set point can be set within a minimum and maximum val-
ue as indicated respectively on Par. 23 and 24 as shown in the
figure.
The outdoor temperature sensor (accessory) is not required and
if connected the outdoor temperature that is measured does
not influence the setpoint that has been set.
49
COMMISSIONING AND MAINTENANCE
"
"
"
61.5 °C
" "