Moving And Removing The Packing; Thermal Module Assembly - Riello Condexa PRO Series Installation, Technical And Maintenance Manual

2.5

Moving and removing the packing

9
Do not remove the cardboard packaging until your reach the
installation location.
9
Before handling the appliance and removing the packaging,
wear PPE and use tools suitable for the appliance's size and
weight.
9
This step must be carried out by several individuals equipped
with suitable means with respect to the appliance's size.
Make sure that the load is not unbalanced during handling.
Proceed as follows to remove the packing:
− Remove the strapping that secures the cardboard pack-
aging to the pallet
− Remove the cardboard
− Remove edge protectors (1)
− Remove the Styrofoam protection (2)
− Remove the protective bag (3)
2
3
1
2.6

Thermal module assembly

Thermal modules Condexa PRO are supplied complete with a
wall-mounting bracket.
9
Check that the wall on which the appliance is to be fitted is
sufficiently solid and supports safe screw fixing points.
9
The appliance's height must be selected so as to facilitate
dismantling it and maintaining it.
Model
Condexa PRO 35 P
1
Condexa PRO 50 P
Condexa PRO 57 P
Condexa PRO 70 P
Condexa PRO 90
Condexa PRO 100
1
Condexa PRO 115
Condexa PRO 135
For installation:
17
− Position the bracket (1) onto the wall (2), at the point
where you wish to install the appliance
− Ensure that the bracket is horizontal and mark the points
where the holes for fixing plugs must be drilled
− Drill the holes and insert expansion plugs (3)
− Fix the bracket to the wall using the screws (4)
− Secure the appliance onto the bracket
3
1
4
INSTALLATION
H
Height (H) mm
1850<H<2000
1850<H<2000
1850<H<2000
1850<H<2000
1850<H<2000
1850<H<2000
2000<H<2150
2000<H<2150
2