Mitsubishi MELSEC-Q Series User Manual page 146
Channel isolated thermocouple input module, gx-configurator-ti sw1d5c-qtiu-e, programmable controller
Hide thumbs
Also See for MELSEC-Q Series:
- Programming manual (1296 pages) ,
- User manual (814 pages) ,
- Reference manual (532 pages)
Table of Contents
Advertisement
7
ONLINE MODULE CHANGE
7
7.3 Online Module Change Procedure
- 21
7.3.4 When user range setting is used and initial setting was made with GX Configurator-TI (other system
(c) Click the
(d) On the OMC refresh data screen of GX Configurator-TI, set the prerecorded
values and make a OMC refresh data write request. (Refer to Section 5.6.3.)
(e) Monitor the CH
Measured temperature value (Un\G11 to Un\18) to check that
proper conversion has been made.
button to close the System monitor screen.
Advertisement
Table of Contents
Troubleshooting
