Mitsubishi MELSEC-Q Series User Manual page 107

5
UTILITY PACKAGE (GX Configurator-TI)
[Explanation of items]
(1) Items
Setting item
Current value :Monitors the I/O signal states and present buffer memory values.
Setting value :Enter or select the data to be written into the buffer memory for test
(2) Command buttons
Remark
:Displays I/O signals and buffer memory names.
operation.
Displays the current value of the item selected. (This is used
to check the text that cannot be displayed in the current value
field. However, in this utility package, all items can be
displayed in the display fields).
Creates a file containing the screen data in text file format.
Selects whether or not to monitor current values.
/
Performs a test on the selected items. To select more than
one item, select them while holding down the
Closes the currently open screen and returns to the previous
screen.
The following describes an example where sampling processing for the selection
test operation is changed to a 10-time averaging processing setting.
(1) Set Averaging in the setting value field for CH
processing selection.
(2) Set Count in the setting value field for CH
(3) Click the setting value field for CH
(4) After entering the number of times, press the
At this point, nothing has been written to the Q68TD-G-H01.
(5) Select the setting value fields that were specified in steps 1 to 4 while holding
down the key.
Ctrl
(6) Click to execute write operation.
Once writing has been completed, the value that was written will be displayed
in the present value field.
Sampling/Averaging
Time/Count averaging selection.
Time Count averaging setting select.
key.
Enter
5.6 Monitoring/Test
5.6.1 Monitor/test screen
1
2
3
key.
4
Ctrl
5
6
7
8
5
- 20