Mitsubishi MELSEC-Q Series User Manual page 122

6
PROGRAMMING
(3) Program example
6
- 12 6.3 Programs Used on Remote I/O Network
6.3.1 Program example when utility package is used
(b) Automatic refresh settings (Refer to Section 5.5)
Set the CH1 to CH3 temperature measurement values and error code.
(c) Write of intelligent function module parameters (refer to Section 5.3.3)
The intelligent function module parameters are written to the remote I/O station.
Perform this operation on the parameter setting unit selection screen.
POINT
To write the intelligent function module parameters, set the target remote I/O
station from [Online] - [Transfer setup] on GX Developer.
They can be written by:
• Directly connecting GX Developer to the remote I/O station.
• Connecting GX Developer to another device such as a CPU module and
passing through the network.
Read of conversion completion flag
Read of CH1 measured
temperature value
Read of CH2 measured
temperature value
Read of CH3 measured
temperature value
Read of disconnection state
monitor flag
Processing at CH1 disconnection
Processing at disconnection status
confirmation
status confirmation
Turns ON error clear request (YF).
Outputs error code in BCD.
Turns ON error clear request (YF).
Turns OFF error clear request (YF).