Online Module Change Procedure; When Factory Default Is Used And Initial Setting Was Made With Gx Configurator-Ti - Mitsubishi MELSEC-Q Series User Manual

7
ONLINE MODULE CHANGE
7.3

Online Module Change Procedure

There are the following online module change procedures depending on whether the user
range setting has been made or not, whether the initial setting of GX Configurator-TI has
been made or not, and whether the other system exists or not.
Range setting
Factory setting
Factory setting
User range setting
User range setting
User range setting
User range setting
7.3.1 When factory default is used and initial setting was made with GX
Configurator-TI
(1) Conversion disable
(a) Set conversion enable/disable setting (Un\G0) for all channel conversion disable

7.3.1 When factory default is used and initial setting was made with GX Configurator-TI

Table 7.2 Online module change procedures
Initial setting
GX Configurator-TI
Sequence program
GX Configurator-TI
GX Configurator-TI
Sequence program
Sequence program
and turn Operating Condition Setting Request (Y9) from OFF to ON to stop
conversion.
After confirming that conversion has stopped with the Conversion Completion
Flag (Un\G10), turn off Operating Condition Setting Request (Y9).
Other system
—
—
Present
Absent
Present
Absent
7.3 Online Module Change Procedure
1
2
Reference section
Section 7.3.1
Section 7.3.2
Section 7.3.3
Section 7.3.4
3
Section 7.3.5
Section 7.3.6
4
5
6
7
8
7
- 4