Mitsubishi MELSEC-Q Series User Manual page 145

7
ONLINE MODULE CHANGE
(3) Mounting of new module
(4) Operation check
7.3.4 When user range setting is used and initial setting was made with GX Configurator-TI (other system
(a) Mount a new module to the same slot, and install the connector.
(b) After mounting the module, click the
"RUN" LED is lit. Module Ready (X0) remains OFF.
(a) To make an operation check, click the
resumption.
(b) Click the
button and make sure that the
button to leave the "Online module change" mode.
7.3 Online Module Change Procedure
button to cancel control
7
1
2
3
4
5
6
7
8
- 20