Offset/Gain Temperature Setting Value (Un\G28 To Un\G43); Warning Output Enable/Disable Setting (Un\G46) - Mitsubishi MELSEC-Q Series User Manual

3
SPECIFICATIONS
3.4.11
(1) Specify with 16-bit signed binary for each channel.
(2) Set a value in units of 0.1 .
(3) When turning ON the channel change request (YB) in the offset/gain
3.4.12
(1) Select whether to enable or disable warning output of process alarm or
(2) The default value is set to "disable" for all channels.
(3) To activate the warning output enable/disable setting, turning ON/OFF
3
- 37 3.4 Buffer Memory
3.4.11 CH[] offset/gain temperature setting value (Un\G28 to Un\G43)
CH[ ]

offset/gain temperature setting value (Un\G28 to Un\G43)

setting mode, the measured temperature value is corrected to the
written value of this area.
POINT
(1) High accuracy is ensured for the offset and gain temperature setting values
when the minimum and maximum temperatures of the operating range are
used to compensate errors.
(2) Set the offset and gain temperature setting values while reading the
measured temperature value.
(3) Always set the offset and gain temperature setting values to satisfy the
following conditions. An error (error code 41 , 42 ) occurs if the conditions
are not satisfied.
Condition 1: Within the input enabled range
Condition 2:
(Gain temperature setting value) - (offset temperature setting value) > 0.1[ ]
(4) By executing the user range write request (YA), the offset and gain
temperature setting values are stored into the flash memory of the Q68TD-G-
H01 and the values are not erased at power-off.

Warning output enable/disable setting (Un\G46)

rate alarm for each channel.
b15 b14 b13 b12 b11 b10
CH8 CH7 CH6 CH5 CH4 CH3 CH2 CH1
Rate alaram setting
the operating condition setting request (Y9) is required.
b9 b8 b7 b6 b5
CH8 CH7 CH6 CH5
Process alarm setting
0: Enable, 1: Disable
b4 b3 b2 b1 b0
CH4 CH3 CH2 CH1