Mitsubishi MELSEC-Q Series User Manual page 131

7
ONLINE MODULE CHANGE
(c) After confirming that the "RUN" LED of the module has turned off, remove the
POINT
(3) Mounting of new module
(a) Mount a new module to the same slot and install the external wiring.
(b) After mounting the module, click the
(4) Operation check
(a) To make an operation check, click the
7.3.1 When factory default is used and initial setting was made with GX Configurator-TI
external wiring and dismount the module.
Always dismount the module. If you execute mounting confirmation without
dismounting the module, the module will not start properly and the "RUN" LED will
not be lit.
"RUN" LED is lit. Module Ready (X0) remains OFF.
resumption.
button and make sure that the
button to cancel control
7.3 Online Module Change Procedure
1
2
3
4
5
6
7
8
7
- 6