Grundfos CIM 150 PROFIBUS DP Functional Profile And User Manual page 32

Appendix
The appendix describes the parts of the CIM 500 webserver
needed for the configuration of a PROFINET IO ethernet
connection. For other CIM 500 webserver features, not
specifically related to PROFINET IO, see the installation and
operating instructions for CIM 500.
A.1 How to configure an IP address on your PC
For connecting a PC to CIM 500 via ethernet, the PC must be set
to use a fixed (static) IP address belonging to the same
subnetwork as CIM 500.
1. Open "Control Panel".
2. Enter "Network and Sharing Center".
3. Click "Change adapter settings".
4. Right-click and select "Properties" for ethernet adapter.
Typically "Local Area Connection".
5. Select properties for "Internet Protocol Version 4(TCP/IPv4).
6. Select the "Alternate Configuration" tab.
7. Configure an IP address and subnet mask to be used by your
PC. See fig. 1.
Example from Windows
Fig. 1
A.2 Webserver configuration
The built-in webserver is an easy and effective way to monitor the
status of CIM 500 and configure the available functions and
Industrial Ethernet protocols. The webserver also makes it
possible to update the firmware of CIM 500, and store or restore
settings.
Before configuration
• Check that the PC and CIM 500 are connected via an ethernet
cable.
• Check that the PC ethernet port is set to the same network as
CIM 500. For network configuration, see section
configure an IP address on your
To establish a connection from a PC to CIM 500 the first time, the
following steps are required:
1. Open a standard Internet browser and type 192.168.1.100 in
the URL address field.
2. Log in to the webserver.
32
A.1 How to
PC.
Pumpland.ru
1