Alarms And Warnings - Grundfos CIM 150 PROFIBUS DP Functional Profile And User Manual

7.7 Alarms and warnings

Module Name Description
3 WarningCode Code for booster system warning.
4 FaultCode Code for booster system alarm.
In the WarningCode module, the cause of a booster system
warning can be read. A warning has no influence on the booster
system operation.
In the FaultCode module, the cause of a booster system alarm
can be read. A booster system alarm always leads to a reaction in
the booster system operation, usually all pumps are stopped, but
some Hydro MPC or Control MPC alarms have programmable
alarm action types.
The complete list of possible alarm and warning codes is shown
below.
Code Alarm/warning description
3 External fault signal
10 Communication fault, pump
80 Hardware fault, IO 351 pump module
80 Hardware fault, IO 351 I/O module
83 Verification error, EEPROM parameter area
88 Sensor fault, general measuring sensor
89 Signal fault, closed-loop feedback sensor
91 Temperature sensor 1 signal fault
157 Real Time Clock error
161 Sensor supply fault, 5 V
162 Sensor supply fault, 24 V
165 Signal fault, analog input A1
166 Signal fault, analog input A2
167 Signal fault, analog input A3
175 Temperature sensor 2 signal fault
190 Limit exceeded, supervised item 1
191 Limit exceeded, supervised item 2
203 Alarm on all pumps
204 Inconsistency between sensors
208 Operation outside performance range
210 High pressure
211 Low pressure
213 VFD not ready
214 Water shortage
215 Soft pressure buildup timeout
216 Pilot pump alarm
219 Pressure relief not adequate
231 Ethernet: No IP address from DHCP server
232 Ethernet: Auto-disabled due to misuse
248 Fault, battery/UPS
Pump alarms. See section
From device
modules 29 to
1)
For Hydro/Control MPC and Multi-E model H and later, it can
be automatic (A) or selectable Automatic/Manual (A/M).
2)
For Hydro/Control MPC and Multi-E model H and later, it can
be none or programmable (Prog.).
Event action programmable are Stop, Stop with delay, Min.,
UserDef, Max., Pumps in local, Emergency run.
The Hydro Multi-E model G is always stopped in case of an
alarm.
7.9 Zone pump modules (ZonePumpModule,
34).
Pumpland.ru
1)
Reset type Action type
A/M Prog.
A None
A None
A None
A None
A None
A/M Prog.
A/M Prog.
A None
A None
A None
A/M Prog.
A/M Prog.
A/M Prog.
A/M Prog.
A/M Prog.
A/M Prog.
A/M Prog.
A None
A/M Prog.
A/M Prog.
A/M Prog.
A None
A/M Prog.
A/M Prog.
A None
A None
A None
A None
A None
- None
2)
17