Grundfos CIM 150 PROFIBUS DP Functional Profile And User Manual page 20

Module Name
28 PumpsCommFault
41 UserSetpoint
42 AnalogueInfluence
43 NoOfPowerOn
44 FeedBackSensorUnit
45 FeedbackSensorMin
46 FeedbackSensorMax
51 AutoModePumps
52 FlowMeasurement1
53 FlowMeasurement2
53 FlowMeasurement2
58 SelectedFeedbackSensor
S: Sensor required.
●: Always available.
●*: Hydro Multi-E model G only.
For Hydro/Control MPC, see the table below.
●**: MPC-E only.
●***: CU 352 only.
20
Data
Unit Description
type
One bit for each pump indicating that there is no
communication with the pump.
Logical "1": No communication with the pump.
0: Communication fault, zone pump 1
1: Communication fault, zone pump 2
5 Bits 2: Communication fault, zone pump 3
3: Communication fault, zone pump 4
4: Communication fault, zone pump 5
5: Communication fault, zone pump 6
6: Communication fault, pilot pump
7: Communication fault, backup pump.
User setpoint as written from the bus or selected on the
booster.
8 %
See description of scaling for a setpoint in
module (ControlModule, module
8 % Influence from analog input.
8 - Number of power-on cycles.
Scaling unit for the closed-loop feedback sensor
0: bar 7:
1: mbar 8:
2: m 9:
5 Enum
3: kPa 10: °C
4: psi 11: °F
5: ft 12: %
3
6: m /h 13: m
Sensor
6 Minimum value for the closed-loop feedback sensor.
unit
Sensor
6 Maximum value for the closed-loop feedback sensor.
unit
One bit for each pump indicating if the pump is
commanded to stop from PROFIBUS/PROFINET or is in
auto mode, controlled from CU 352.
Logical "1": Pump in auto mode.
0: Zone pump 1 in auto mode
1: Zone pump 2 in auto mode
2: Zone pump 3 in auto mode
5 Bits
3: Zone pump 4 in auto mode
4: Zone pump 5 in auto mode
5: Zone pump 6 in auto mode
6: Pilot pump in auto mode
7: Backup pump in auto mode.
The data module ControlPumps (module 50) is used to
command the individual pumps.
3
6 0.1 m /h Flow measurement 1 from sensor.
3
6 0.1 m /h Flow measurement 2 from sensor.
3
6 0.1 m /h Flow measurement 3 from sensor.
Read selected feedback sensor type
5 Enum 3: Flow sensor
6: Pressure sensor
Pumpland.ru
7.2 Control
2).
3
m /s 14: l/h
l/s 15: l/min
gpm 16: gal/h
17: gal/s
3
18: ft /h
3
19: ft /min
3 3
/min 20: ft /s
● ● ● ●
● - ● ●
● - ● ●
● - - -
●* - ● ●
● - ● ●
● - ● ●
●*** - - -
S - - -
S - - -
S - - -
●*** - - -