National Instruments GPIB-PCII Getting Started page 13

Figure 1-1. GPIB-PCII/IIA Interface Board......................................... 1-1
Figure A-1. GPIB-PCII/IIA Parts Locator Diagram ............................. A-1
Figure A-2. GPIB-PC Mode Selection Settings ....................................A-2
Figure A-3. 7210/9914 Mode Selection Settings ..................................A-4
Figure A-4. Base I/O Address Switch Settings for GPIB-PCII............. A-6
Figure A-5. Base I/O Address Switch Settings for GPIB-PCIIA..........A-7
Figure A-6. Default Interrupt Jumper Setting for GPIB-PCII............... A-12
Figure A-7. Default Interrupt Jumper Setting for GPIB-PCIIA............A-13
Figure A-8. Interrupt Jumper Settings for GPIB-PCIIA ....................... A-14
Figure A-9. DMA Channel Jumper Settings ......................................... A-18
Figure A-10. Ground Configuration Jumper Settings ............................. A-20
Table 2-1. GPIB-PCII/IIA Default Settings ........................................2-1
Table A-1. Factory Default Settings and Available Configurations
for GPIB-PCII Mode ......................................................... A-3
Table A-2. Factory Default Settings and Available Configurations
for GPIB-PCIIA Mode....................................................... A-3
Table A-3. PC I/O Address Map..........................................................A-9
Table A-4. PC Interrupt Assignment Map ........................................... A-16
Table A-5. DMA Channels for the GPIB-PCII/IIA............................. A-18
© National Instruments Corp.
Figures
Tables
xiii PCII/IIA and NI-488.2 MS-DOS
Contents