7210/9914 Mode Selection; Figure A-3. 7210/9914 Mode Selection Settings - National Instruments GPIB-PCII Getting Started

Changing Hardware and Software Configuration Settings Appendix A
If you make any changes to these settings, record the new settings in the GPIB-
PCII/IIA Hardware and Software Configuration Form in Appendix B and go on
to Step 2 - Software Configuration at the end of this appendix.

7210/9914 Mode Selection

The GPIB-PCII/IIA can emulate many IEEE-488 interface boards that use the
TI 9914A GPIB Controller chip as well as the 7210 chip. Use switch 8 in
switch block U2 to select either TI 9914A mode or NEC 7210 mode. For
normal operation with National Instruments software, leave this switch in the
7210 position. Figure A-3 shows the 7210/9914 mode selection switch settings
for 7210 mode and 9914 mode.
Key
= not used to select the 7210/9914 mode
U2 U2
7210 9914 7210 9914
b. 9914 Mode
a. Default Mode
Selected
(7210) Selected

Figure A-3. 7210/9914 Mode Selection Settings

PCII/IIA and NI-488.2 MS-DOS A-4 © National Instruments Corp.