Table of Contents
Advertisement
Introduction
To determine how your board was configured to function at the factory,
check the identifying label on the mounting bracket of the interface board,
beside the GPIB connector.
The default configuration of the board can also be determined by checking
the assembly number located on the component side of the board. The
assembly numbers for the board configurations are as follows:
Check that the setting of the GPIB-PC mode switch is consistent with the
configuration indicated on the identifying label. For information on the
GPIB-PC mode switch, refer to Appendix A, Changing the Hardware and
Software Configuration Settings, later in this manual.
PCII/IIA and NI-488.2 MS-DOS
GPIB-PCIIA
GPIB-PCII
1-2
181065-01
181065-02
© National Instruments Corp.
Chapter 1
Advertisement
Table of Contents
