MICRO-EPSILON colorCONTROL ACS7000 Instruction Manual page 36

Operation
RS422, Measured data in XYZ / measured data in RGB / mea-
color measure sured data in L*a*b* / measured data in L*u*v* /
Frequency and control events / Exposure time in digits /
Detector temperature / Light source temperature / Light
sensor brightness / Light sensor blue / Light sensor
green / Light sensor red / Profile counter / Timestamp /
Error codes
RS422, Measured data in L*a*b* / number of detected color /
color detection, number of nearest color / minimal color distance
best hit
Frequency and control events / Exposure time in digits /
Detector temperature / Light source temperature / Light
sensor brightness / Light sensor blue / Light sensor
green / Light sensor red / Profile counter / Timestamp /
Error codes
RS422, Measured data in L*a*b* / number of detected color /
color detection, number of nearest color
selection
Frequency and control events / Exposure time in digits /
Detector temperature / Light source temperature / Light
sensor brightness / Light sensor blue / Light sensor
green / Light sensor red / Profile counter / Timestamp /
Error codes
RS422,
video/spectrum
Frequency and control events / Exposure time in digits /
Detector temperature / Light source temperature / Light
sensor brightness / Light sensor blue / Light sensor
green / Light sensor red / Profile counter / Timestamp /
Error codes
Ethernet set- IP settings of the device
tings
Ethernet measured value transfer settings
Settings RS422 Baud rate
Settings Color- Output mode
Out
Binary format
Reference color
Settings Ether- Operating mode after system start
CAT
Color measurement. Output of the color values determined for the target. The color space and the measurement
conditions (standard light type / standard observer) are specified by the user for this. The measured values are out-
put automatically.
Fields with a grey
background re-
quire a selection.
Dark bordered
fields require the
Value
specification of a
value.
colorCONTROL ACS7000
no output / binary (0..15) / color
(1..4) / L*, a*, b* check
1 corresponds to 0001 / 1 corresponds to 1000
see Preferences > Color table menu
Select the relevant check boxes to choose
which data are used for transmission. The
data are output one after the other in a de-
fined sequence.
Static IP Values for IP address /
address / gateway / subnet mask.
DHCP Only for static IP address
Server / Values for port and IP ad-
Client dress
TCP/IP / UDP/IP
9.6 / 115.2 / 230.4 / 460.8 / 691.2 /
921.6 / 1500 / 2000 / 3500
Use of the four color switching outputs, see
Chap. 4.4.4.
Use of the optical presentation ColorOut
in the "Color Table" menu and in the "Color
Detection" slide.
( in L*a*b*-Check mode only)
Ethernet / EtherCAT
Page 36