Setting Passwords; Setting Date And Time; Setting The Time Format; Setting The Language - Dräger Polytron 7000 Instructions For Use Manual

9.2.6 Testing the alarm relay and the fault relay
During the relay test, an error state is simulated and the corresponding relay is
energised.
1. Select Settings > Instrument > Alarm and the desired signal condition.
2. Select Enable or Disable.
9.3

Setting passwords

1. Select Settings > Instrument > Passwords and the password to be changed.
2. Set the password.
9.4

Setting date and time

1. Select Settings > Instrument > Date and time.
2. Select the line for date or time.
3. Make the settings.
9.5

Setting the time format

1. Select Settings > Instrument > Time format.
2. Select the line for the time format of date or time.
3. Select the time format (European or American).
9.6

Setting the language

1. Select Settings > Instrument > Language.
2. Select the language.
9.7 Configuring the function key
1. Select Settings > Instrument > Function key.
2. Select the function to be called.
1) Only works with the data dongle
2) Only works with the diagnostic dongle
Set Alarm A1 Simulate pre-alarm (alarm 1).
Set Alarm A2 Simulate main-alarm (alarm 2).
Set Fault Simulate fault signal.
Displays the measured values of the sensor graphically
1)
Show graph
on a time axis.
Show Fault Shows existing errors.
Show Notice Shows existing warnings.
Show Fault Codes Shows fault codes for existing errors.
Shows the sensor vitality.
2)
Sensor Vitality
Dräger Polytron 7000
Device settings