New And Changed For Headset Firmware 2.0(1); New And Changed For Headset Firmware 1.5(1) - Cisco 500 Series Administration Manual

New and Changed for Headset Firmware 2.0(1)

New and Changed for Headset Firmware 2.0(1)
The following table shows the changes made for Firmware Release 2.0(1).
Table 2: Cisco Headset 500 Series Administration Guide Revisions for Firmware Release 2.0(1)
Feature
Electronic Hookswitch is now a user controlled
feature on Cisco IP Phones
New chapter: Headset Management on Cisco
Unified Communications Manager Version
12.5(1) or Older
Troubleshoot: Poor Audio Quality
Medium Range DECT Range setting
Headset parameter: Firmware Source

New and Changed for Headset Firmware 1.5(1)

All references to Cisco Unified Communications Manager documentation have been updated to support all
Cisco Unified Communications Manager releases.
Table 3: Cisco Headset 500 Series Administration Guide Revisions for Firmware Release 1.5(1)
Feature
Headset serviceability through Cisco
Unified Communications Manager
Administration
Remote problem report tool activation is
now supported.
Cisco Headset 500 Series Administration Guide
2
Updated Section
The hookswitch parameter has been removed from
Headset 500 Series Parameters on Cisco Unified
Communications Manager, on page 24
Headset Management on Cisco Unified Communications
Manager Versions Older than 12.5(1)SU1, on page 29
Poor Audio Quality, on page 37
Headset Template Management, on page 17
Headset Template Management, on page 17
Updated Section
• Headset Management Overview, on page 11
• Headset Template Management, on page 17
• Configure a Headset Template, on page 20
• Headset Inventory Management, on page 21
• View Headset Inventory, on page 22
• Get an Aggregate Summary of Your Deployed Headsets,
on page 23
• Generate PRT for Endpoints on Unified CM, on page 37
Cisco Headset 500 Series Set Up
Cisco