Deploy Your Cisco Headset 560 Series - Cisco 500 Series Administration Manual

Deploy Your Cisco Headset 560 Series

Note
What to do next
Your headsets function with full call control capabilities on a Cisco IP Phone without any changes through
Cisco Unified Communications Manager Administration. However, some headset features are only available
after activation by a Cisco Unified CM Administrator. See
more information.
Deploy Your Cisco Headset 560 Series
This task describes the installation steps for the Cisco Headset 560 Series.
Procedure
Step 1
Plug in the USB cable at the back of the base. On the multibase, the USB port is located between the micro-USB
port on the left and the power plug on the right.
Cisco Headset 500 Series Administration Guide
4
Headset management in the Cisco Headset 520 Series and Cisco Headset 530 Series is only available
with a USB connection.
Cisco Headset 500 Series Set Up
Cisco Headset Administration, on page 11 for