Integrated Cnvi Selection For M2E1 (Jp4); Flash Descriptor Security Override Selection (Jp5); At / Atx Power Mode Selection (Jp6); Table 38: Pin Assignment Jp4 - Kontron 3.5"-SBC-WLU User Manual

7.18.4. Integrated CNVi Selection for M2E1 (JP4)

The 2.0 mm pitch "Integrated CNVi Selection for M2E1" jumper (JP4) can be used to select whether or not to enable
CNVi device in M.2 Key E slot.

Figure 33: Integrated CNVi Selection JP4

Table 38: Pin Assignment JP4

Jumper 1 Position
Pin 1-2 Pin 2-3
X -
- X
"X" = Jumper set (short) and "-" = jumper not set (open)

7.18.5. Flash Descriptor Security Override Selection (JP5)

The 2.0 mm pitch "Flash Descriptor Security Override Selection" jumper (JP5) can be used to specify whether to
override the flash descriptor.

Figure 34: Flash Descriptor Security Override Selection JP5

Table 39: Pin Assignment JP5

Jumper 1 Position
Pin 1-2 Pin 2-3
X -
- X
"X" = Jumper set (short) and "-" = jumper not set (open)

7.18.6. AT / ATX Power Mode Selection (JP6)

The 2.0 mm pitch jumper JP6 can be used to select AT power mode or ATX power mode.

Figure 35: AT / ATX Power Mode Selection JP6

www.kontron.com
Description
Integrated CNVi Disabled
Integrated CNVi Enabled
Description
Normal Operation
Flash Security Override
1
2
3
1
2
3
3.5"-SBC-WLU - User Guide, Rev. 1.0
// 55