KidKraft Appleton Play System F24148 Installation And Operating Instructions Manual page 18

Step 5: Wall Side Assembly
A: To 2 (1771) Posts loosely attach (1759) SW Floor and (1769) Ground Side with 4 (H2) 1/4 x 2" Bolts (with
lock washer, flat washer and t-nut) per board. (fig. 5.1)
Fig. 5.1
1797
H2
x 2
B: Loosely attach (1797) Side Top to each (1771) Post with 2 (H2) 1/4 x 2" Hex Bolts (with lock washer, flat
washer and t-nut). These Hex Bolts are to be installed from the back of the assembly. (fig. 5.1)
C: Attach (2783) Tarp Upright to (1759) SW Floor and (1797) Side Top with 2 (H2) 1/4 x 2" Hex Bolts (with lock
washer, flat washer and t-nut). Tighten all bolts and attach (1797) Side Top to each (1771) Post with 1 (S2) #8 x
1-1/2" Wood Screw per post. (fig. 5.1 and 5.2)
D: Attach (1766) Corner Block flush to angled extension of (1769) Ground Side with 2 (S2) 8 x 1-1/2" Wood
Screws as shown in fig. 5.2 and 5.3.
Fig. 5.2
2783
1797
Wood Parts
2 x Post 2 x 4 x 74"
1771
1 x Ground Side 1 x 5 x 42-1/4"
1769
1 x SW Floor 1 x 6 x 26-7/8"
1759
1 x Corner Block 2 x 3 x 4-1/2"
1766
1 x Side Top 1 x 4 x 51-1/2"
1797
S2
1759
Back
1771
1769
S2
1 x Tarp Upright 2 x 2 x 60"
2783
H2
x 4
Notice hole towards back
1769
H2
Flush
1766
Hardware
12 x 1/4 x 2" Hex Bolt
H2
(1/4" lock washer, 1/4" flat washer, 1/4" t-nut)
4 x #8 x 1-1/2" Wood Screw
S2
18
1759
H2
x 4
1769