KidKraft Appleton Play System F24148 Installation And Operating Instructions Manual page 17

Step 4: Swing Side Assembly
Note: Pre-drill all holes using a 1/8" drill bit before installing the lag screws.
A: To 2 (1771) Posts attach (1770) SW Ground and (1759) SW Floor using 4 (H2) 1/4 x 2" Hex Bolts (with lock
washer, flat washer and t-nut) in each board. Be sure to keep bolts loose. (fig. 4.1)
1770
H2
B: Attach (1797) Side Top to each
(1771) Post with 2 (H2) 1/4 x 2" Hex
Bolts (with lock washer, flat washer and
t-nut) Hex Bolts are to be installed from
the back of the assembly. Be sure to
keep bolts loose. (fig. 4.2)
C: Make sure assembly is square and
then fasten (0369) Lower Diagonal to
(1770) SW Ground at an angle using 1
(H2) 1/4 x 2" Hex Bolt (with lock washer,
flat washer and t-nut) and to (1771) Post
using 1 (LS3) 1/4 x 3" Lag Screw (with
flat washer). (fig 4.2).
D: Attach (2782) SW Mount to (1759)
SW Floor and (1797) Side Top with
2 (G4) 5/16 x 4" Hex Bolts (with lock
washer, flat washer and t-nut). (fig. 4.2)
E: Tighten all bolts then attach (1797)
Side Top to each (1771) Post with 1 (S2)
#8 x 1-1/2" Wood Screw per post. (fig.
4.2)
Wood Parts
2 x Post 2 x 4 x 74"
1771
1 x SW Ground 1 x 5 x 60-1/4"
1770
1 x SW Floor 1 x 6 x 26-7/8"
1759
1 x Lower Diagonal 2 x 3 x 37"
0369
1 x SW Mount 2 x 4 x 60"
2782
1759
Notice hole
location
H2
1 x Side Top 1 x 4 x 51-1/2"
1797
H2
Fig. 4.2
LS3
0369
1759
1770
1771
H2
11 x 1/4 x 2" Hex Bolt (1/4" lock washer, 1/4" flat washer, 1/4" t-nut)
G4
2 x 5/16 x 4" Hex Bolt (5/16" lock washer, 5/16" flat washer, 5/16" t-nut)
1 x 1/4 x 3" Lag Screw (with 1/4" flat washer)
LS3
2 x #8 x 1-1/2" Wood Screw
S2
17
1771
H2
1771
S2
S2
G4
Hardware
Fig. 4.1
1797
2782
H2
G4
H2