Appendix
A
Connector Pinouts
QuickSet® Switch
Figure A–5 shows the location of the QuicSet switch and access screw.
FIGURE A–5.
Switch and
Access
Screw
The QuicSet switch is located beneath the access screw, as shown at location S1
in Figure A–5. To access the QuicSet Switch, remove the sealing screw with a
Phillips screwdriver. To maintain the IP rating of the chassis, the sealing screw
must be installed and tightened to 0.6 Nm. If IP rating is not critical to your
application, hand tighten snug. Do not overtighten!
A-8
QuicSet® Switch & Access Screw "S1" – Rear View
SIMATIC HawkEye™ 1600T Smart Camera Guide
S1
Rev. 1E, Nov 2007