Table of Contents
Advertisement
Mounting Using Front Block
Note: Do not insulate the mounting block. The mounting block of the SIMATIC
HawkEye™ is part of the heat dissipation system, and metal-to-metal contact is
required for effective cooling. Refer to Appendix C, "Specifications," for
mounting block dimensions.
You can mount the SIMATIC HawkEye™ 1600T using the M4 holes located on
the top, bottom, and each side of the front block, as shown in Figure 2–5.
FIGURE 2–5.
Caution
Using screws that are too long for the threaded holes may damage the
SIMATIC HawkEye™ 1600T. The accessory mounting blocks use 10mm
machine screws.
Rev. 1E, Nov 2007
Locations for Mounting Using Front Block
M4 x .7 x 10
SIMATIC HawkEye™ 1600T Smart Camera Guide
SIMATIC HawkEye™ 1600T
2
2-11
Advertisement
Table of Contents
