Installation; Inserting The Sim Card; Connecting The Antenna/S - Perle IRG5140+ Series Hardware Installation Manual

Installation

The steps for a typical installation are:
1. Inserting the SIM card/s. See
2. Connecting the antenna/s. See
3. Connecting the Ethernet Ports. See
4. Connecting to the Console Port in Console Mode. See
Mode
5. Using the Console port as a virtual Ethernet port. See
net over USB Port
6. Connecting the power. See
7. Logging into the IRG5140. See

Inserting the SIM card

The IRG5140 comes with two 6-pin SIM sockets for mini-SIM (2FF) cards.
Ensure the power is disconnected before you insert the SIM card/s.
1. Using your Phillips screwdriver, removed the screw from the panel covering the SIM slots. Gen-
tly pry the cover loose from the opening.
2. Align the SIM card so that the SIM card will slide into the top slot (slot#1). Each SIM card has a
notched corner for orientation and the SIM card can only be inserted the correct way. You will
hear an audible click when the SIM is inserted correctly. Always populate slot#1 first. Add a sec-
ond SIM card if your network setup requires it.
3. Align the SIM cover plate and secure the plate with the screw.
Do not force the SIM(s) card in or you may damage the card or your
Note:

Connecting the Antenna/s

The IRG5140 has three SMA female antenna connectors:
• Main Cellular antenna connector
• Rx Diversity antenna connector
• GNSS antenna connector
1. Connect your cellular antenna to the SMA cellular antenna connector labeled Main
Inserting the SIM card
Antenna/s
Ethernet LAN Ports
Connecting the Power
Fast Setup
IRG5140+
Perle Series Router Hardware Installation Guide
Connecting to the USB-C port in Console
Connecting to the USB-C port as an Ether-
or
Connecting to the USB-C port in Console Mode
Connecting the Antenna/s
IRG5140 router
.
7