Operation; Reset / Factory Default / Safe Mode - Perle IRG5140+ Series Hardware Installation Manual

If you are using a cable that is longer than two meters, we recommend the following:
Wire gages (AWG):
• 22 gauge wire or up to 4 meters (13ft)
• 20 gauge wire for up to 6 meters (20ft)
• 18 gauge wire for up to 12 meters (40ft)
Cable and connector must be rated for minimum 76°C (168.8°F)
Before servicing this product ensure the power source has been disconnected. Electrical
Note:
installations should be performed by personnel thoroughly trained in safe electrical wiring
procedures.

Operation

Reset / Factory Default / Safe Mode

The table below shows how the reset button can be used to accomplish the below function.
Reset Button
Mode Description
Restart Press and Release the
Reset button when the
router is running
Factory Press Reset and Hold for
default 10 seconds when the
router is running
Safe Mode Press the Reset button
while powering up
IRG5140+
Perle Series Router Hardware Installation Guide
LEDs
Power LED will
begin to blink
amber
All LEDs flash
Amber, release
Reset button, then
Power LED flashes
Amber.
All LEDs, except
power blinking
Amber
Reset / Factory Default / Safe Mode
System Status
Reboots. All configuration and
files will remain the same.
Reboots and resets the
configuration to the Perle
factory default configuration.
All configuration, user IDs,
passwords and security
certificates are deleted.
Saves the startup config

Boots with no config file

Allows you to do setup

mode
10