Connecting To The Usb-C Port As An Ethernet Over Usb Port; Connecting The Power - Perle IRG5140+ Series Hardware Installation Manual

Connecting to the USB-C port as an Ethernet over USB Port

In this mode, the USB-C port behaves as if a PC is connected to the Ethernet port, allowing access to
networks and the Internet.
See the Perle IRG5000 Series Router User's Guide and the Perle IRG5000 Series Router CLI Refer-
ence Guide for more information on setting this parameter.

Connecting the Power

The power connector can be found at the top of the router. The connector can be removed from the
unit for easy insertion of wires. Once all wires have been secured to the power connector, the connec-
tor can be re-inserted into the top of the router.
The connector includes the following items.
P1 - Primary power connection
P2 - Secondary power connection
R- Relay connection
IN - Digital Input connection
A "Grounding Lug" is available if your installation requires additional grounding.
The IRG5140 Router has two power inputs that can be connected simultaneously to provide redun-
dant power. If one power source fails, the other source acts as a backup and powers the Router.
Wiring with suitable temperature ratings must be used. Refer to specification section for
details. Use copper wire only if the terminal is only for connection to copper wire.
1. Ensure the power source is off prior to connection
2. Strip both (18-22AWG) wires 7 mm
3. Loosen the terminal block screws and connect positive (+) / negative (-) wires into the +/- termi-
nals
4. Tighten terminal screws (0.5 - 0.6 Nm torque). Ensure the wires are securely fastened.
5. Re-insert the Terminal Block connector if removed, Turn on power source. Check LED indicators
in the guide for power status
6. Connect P2 (power source 2, beginning at Step 1)
7. Ensure that there is one individual conductor for each clamping point.
IRG5140+
Perle Series Router Hardware Installation Guide
Connecting the Power
9