Husqvarna Rider 18 ProFlex Workshop Manual page 46

Reparation instructions
4
1 = Axle
2 = Lock nut
• Slowly turn the axle anti-clockwise until the drive
shafts stop rotating backwards and make a mark
on the transmission housing (RS).
• Slowly turn the axle anti-clockwise until the drive
shafts start to rotate forwards.
• Slowly turn the axle clockwise until the drive
shafts stop rotating forwards and make a mark
on the transmission housing (FS).
• Turn the axle clockwise 1/3 of the distance
between the marked stop points.
• Hold the axle (M8) firmly and tighten the lock nut
(M17).
• Check that the drive shafts do not rotate in the
neutral position by slowly transferring the
steering arm to the neutral position from the
forwards and reverse positions.
44
– English
5
1 = Axle
2 = Lock nut
If the drive shafts do not rotate backwards despite
the hexagonal axle having rotated a full turn, the
neutral position is to be adjusted in the following
way:
• Slowly turn the axle anti-clockwise until the drive
shafts start to rotate forwards.
• Slowly turn the axle clockwise until the drive
shafts stop rotating forwards and make a mark
on the transmission housing (FS) and the axle.
• Turn the axle clockwise 8° from the mark on the
transmission housing.
• Hold the axle (M8) firmly and tighten the lock nut
(M17).